Write a test plan and be sure to demonstrate that the specifications are met below the lower limit, in the normal range, and above the upper limit.
The objective of this project is to design a temperature alarm system which measures air temperature and provides an alert when the temperature exceeds its defined upper and lower limit. Specifically, a red LED should turn on when the temperature is lower than the lower limit or higher than the upper limit. When the temperature is between these two limits, a green LED should be on, indicating that the temperature is “normal.”
Lower limit: 70 ℉ Upper limit: 110 ℉
Save your time - order a paper!
Get your paper written from scratch within the tight deadline. Our service is a reliable solution to all your troubles. Place an order on any task and we will take care of it. You won’t have to worry about the quality and deadlines
Order Paper NowThe design will consist of multiple stages as shown below in Figure 1. Note that a thermistor is to be used. Also, for the “Amplification Circuit” block, use an operational-amplifier wheatstone bridge (you will need to find this on the internet). For the thermistor, you should use the internet to find a thermistor you want to use and use its datasheet. A possible alarm circuit is shown in Figure 2. Don’t forget to use commonly available parts.
Figure 1: Block diagram of temperature alarm system
Figure 2
Project Simulation: Once you have designed the circuit, build it and simulate in Multisim using tolerances.
Write a test plan and be sure to demonstrate that the specifications are met below the lower limit, in the normal range, and above the upper limit.
PLACE THIS ORDER OR A SIMILAR ORDER WITH homework handlers TODAY AND GET AN AMAZING DISCOUNT
The post Write a test plan and be sure to demonstrate that the specifications are met below the lower limit, in the normal range, and above the upper limit. appeared first on homework handlers .
