Provide a quick few words about the ending to the stop module of this car. My other classmates have completed the first two sections of my as shown below:

Start Module

The start module is located at the beginning of the timer circuit. The IR LED is connected at the output pin of the 555 Timer. When the circuit is connected to the power supply the IR LED is active and sends out its signal. When the robocar passes the IR LED the signal reflects off it and onto the TSOP4138 receiver. The signal sets the receiver to low which activates the TE pin on the HT12E encoder chip. The TE pin converts the 4-bit data into serial data which is available through Dout. The data from Dout is transmitted to the data input on the RF TX module. The radio frequency is transmitted from here to the RF RX module on the control module to begin the counting.

Display module

The display time counter module starts when the output pin of the 555timer is triggered by the start module . The 555 time then sends a signal to 1 of the 16IC inside the module which starts the timer to start counting which is shown on the 7 segment display.

The timer starts counting from the far right first 7-segment display and once that one reaches 9, the second or middle 7-segment display is trigger through its own 16IC and the timer starts counting on that as well until it reaches 9 again and moves to the last one which is on the far left hand side.

When the stop module is triggered, it sends a signal back to the display module to stop the time whenever its trigger to stop the 7-segment display from counting and the time shown is when the clock or display stop is the time taken to complete the race.

Sample Solution

The post Ending to this circuit – Stop Module of Racer Car appeared first on homework handlers.

Introduction
Impact analysis and identify enterprise environmental factors (EEF) of the project (case study of University
of western Australia).
Body (follow case study)
• Evaluation of the internal and external factors and their impact on project management processes.
• Development of strategies to implement the appropriate actions.
• Drafted communication plan and outcomes to diverse stakeholders.
At end of the report, is required to provide a tow (500-word of personal learning reflection). The reflection
should cover
• What key knowledge and skills you learned through this subject?
• How will they benefit you further study and career?
• Any Good, Bad or Ugly of your total learning experience?
The subject is integrated project management
Conclusion
References
• Burke, R. (2013). Project Management Techniques (2nd ed.). US: Burke Publishing.
• Project Management Institute. (2017). A guide to the project management body of knowledge (PMBOK
Guide) (6th ed.). Newtown Square, PA: PMI.
• Project Management Institute. (2013). A guide to the project management body of knowledge (PMBOK
Guide) (5th ed.). Newtown Square, PA: PMI.

Sample Solution

The post Enterprise Environmental Factors Analysis appeared first on homework handlers.